1. The instrument and all accessories should be stored intact in the instrument box (except for the rod), and the environment should be dry and ventilated.
2. Before using the instrument, read the instructions carefully. You must be familiar with the structure of the instrument and the methods for removing and washing it. Otherwise, it cannot be disassembled.
3. The instrument should be cleaned or disassembled and refueled in time after completion of each measurement.
4. When using, if you find that the rotating parts are loose, or the clearance between the front axle sleeve and the body frame is getting bigger, you should immediately stop using it, check it, and reinstall it. There are two possible reasons why this happens:
(1) Loosen the cap and loosen the bearing. In this case, you need to disassemble the instrument and reinstall it.
(2) The shaft screw is not tightened and the propeller shaft slides outward. Just adjust the position and re-tighten it.
5. If there is no water entering the propeller cavity, the bearing may not be disassembled, as long as it is scrubbed and cleaned in gasoline.
6. When brushing the bearing, only use the soft small clock brush, not hard brush, so as not to damage the finish of the marble.
7. Bearings should be carefully cleaned and refueled when used. In the long-term preservation, inspections should be taken out every six months and refueled. If rust is found, it should be cleaned immediately; if it cannot be repaired, it should be sent to the manufacturer for repair and re-verification.
Life Fitness Accessories,Wholesale Fitness Accessories,Fitness Equipment Accessories,Gym Accessories For Men
Foshan Laijian Fitness Equipment Co., Ltd. , https://www.ljfitnessquipment.com