1. The operator must be familiar with the structure and performance of the machine tool. After being qualified in the examination and mastering the operation and adjustment techniques, the operator can operate independently and strictly prohibit the use of super performance. 2. Before the class, check the machine tool according to the requirements of the equipment inspection card, and add fuel according to the lubrication regulations to check the oil quality, oil content, and lubrication conditions. 3. Check whether each power head, slide table, spindle is abnormal before driving, whether the buttons and switch are in the original position, and whether the size and position of the adjustment block, dead stop, knife, and fixture are correct and the mounting is firm. 4. When loading and unloading the workpiece, safety spreaders and methods must be selected according to the weight and shape of the workpiece, and work closely with the crane operator. The loaded workpiece must be firmly fastened. 5, first run at low speed for 3 to 5 minutes, adjust the knob to adjust the position, observe the action is normal, after confirmation is correct, then the automatic cycle, until the normal work before the Department. 6. Accurately adjust the distance between the fast feed and the work feed, the adjustment gap is generally not less than 10mm, and the mechanical drive cam feed adjustment distance is required to be accurate. 7. Before moving the spindle box, it must be ensured that the sliding surface is clean and well-lubricated. 8. The tool should be changed in time when the tool is worn. It is forbidden to use a blunt or chipping tool to continue cutting. When changing the tool, readjust the distance between the rapid movement and the work advance. 9. Always check the tightening of the workpiece and tool during work and do not loosen it. 10. It is prohibited to change the speed and measure the workpiece when the spindle is running. In the case of drilling, boring and cutting, the tool must not be stopped before it is removed from the workpiece. 11. The guide rail, sliding surface and paint surface of the machine tool are not allowed to place metal objects such as workpieces, blanks, and tools. 12. When the machine tool is faulty or abnormal, it should be immediately stopped, checked, or notified by maintenance personnel. 13. After the work is completed, each power head, handle and button shall be returned to the original position, and the power supply shall be cut off to clean the machine tool. 14. Parts and protective covers of machine tools are not allowed to be removed at will, and all accessories must be properly kept and kept intact. 15. Clean the machine tool before work to keep it tidy and in good condition. Do a good job in the succession work and operation records.
Auto Abc Column Mould Or Mold,Auto Abc Column Mould Osrs,Auto Abc Column Mould Xp,Auto Abc Column Mould Yield
Kunshan Wangdaxin Precision Mould Co., Ltd. , https://www.wdxmould.com