Nowadays, car repair shops are no longer the same type of car repair mode. Even the repairs are different. Some shops choose to make up, while others will make up. So, what's the difference between the different methods?
Tank trucks often get smashed by the messy waste on the way, especially nails. Since there are not many places where tires can be repaired, once the tires are punctured and leaked, most owners can only change their tires first, and then find a small repair shop on the roadside to repair them. Due to the low cost of repairing the tires, most of the ordinary tire repair shops only provide simple external supplements, and glue sticks are used to glue the strong glue into the holes to complete the repairs. The cost for a one-time repair is about 10 yuan.
The riders need to know that this temporary patching is only an emergency solution and is gradually being replaced. This is due to the fact that the externally supplemented material is often not the same strength as the original tire. After repair, it will lead to inconsistent stress on the tire, the tire skeleton will be easily deformed, and the degree of external seal is not high enough for air and water to enter the tire easily. Tire steel wire rust, but also in the high-speed traffic will remain hidden dangers, some tires after only make up for three or four months after the scrapped. Therefore, it is recommended that the owner of the tire repaired external to find a professional repair shop to make up for it.
In contrast, inner tubes can be tedious and must be equipped with professional dismantling tools. The tires are disassembled from the hub, and after the holes are found, they are heated with a special vulcanizing machine. Using this method can also make up a larger wound. However, such hot supplements are more expensive, such as small holes ranging from 15 yuan to 20 yuan, and larger wounds cost about 50 yuan. But the benefits are obvious and safe to use.
The replacement process of excavator hydraulic cylinder is as follows:
1. Turn off the hydraulic system: Before replacing the hydraulic cylinder, it is necessary to turn off the system to avoid liquid leakage in the hydraulic system.
2. Disassembling the hydraulic cylinder: Disassembling the hydraulic cylinder requires the use of tools such as wrenches, screwdrivers, etc. Firstly, the hydraulic pipeline needs to be removed, and then the bolts of the hydraulic cylinder need to be removed to remove the hydraulic cylinder from the machine.
3. Check the hydraulic cylinder: Check if there is any damage to the hydraulic cylinder, and if there is any damage, replace it.
4. Install a new hydraulic cylinder: Install the new hydraulic cylinder onto the machine and secure the cylinder with bolts.
5. Connect hydraulic pipeline: Connect the hydraulic pipeline to the hydraulic cylinder, pay attention to the position and direction of the connection, and ensure that the connection is secure.
6. Test system: after replacing the hydraulic cylinder, it is necessary to test whether the system operates normally, check whether the hydraulic cylinder operates normally, and deal with any problem in time.
7. Cleaning work: Clean the liquid and debris in the hydraulic system to ensure that the system is clean and avoid any impact on the system.
For Kato Cylinder Seal Kit,For Kato Center Joint Seal Kit,Center Joint Seal Kit,Repair Kit For Kato Joystick
Safe Seal Technology Co., Ltd. , https://www.jsspreals.com