Definition: The crusher is a general term for crushing machinery and grinding machinery. The two are generally roughly distinguished according to the size of the discharge size: the content of the material with a particle size greater than 3 mm in the discharge material accounts for more than 50% of the total discharge amount, which is called a crushing machine (also commonly referred to as coarse breaking); and less than 3 mm. The content of the total discharge amount of 50% or more is called a grinding machine. The grinding machine is sometimes referred to as a crusher (ie, finely broken).
General small jaw crushers should pay attention to the following points when working:
1. When the crusher crushes the material, adjust the discharge port of the jaw crusher to crush the material to a certain size;
2. Check the tightness and wear of the V-belt (or flat belt) of the crusher. If it is too tight or too worn, adjust the belt or adjust it in time.
3. Always check the wear of the guards on both sides of the crusher. If the wear is serious, it should be replaced.
4. The opening size of the seesaw should be adjusted in strict accordance with the block size required by the process.
5. When the crusher does not have a protective cover, or the protective cover is not perfect, it is forbidden to start the machine to avoid personal accidents.
6. Move the flywheel or pull the belt with your hand to confirm that the equipment is flexible and can be tested without load.
7. After the crusher equipment is running normally, the feed is allowed to be broken. The addition should be uniform and no other blocks should be allowed.
8. Always pay attention to the discharge situation. If there is any blockage, it should be cleared in time.
9. Before the machine is shut down, all the blocks between the slabs must be broken before they can be shut down.
The company produced heat - resistant steel heat treatment furnace components, products sold throughout the country. In many years of continuous development and development, innovation of a number of new materials, further to meet the heat resistant leather and deformation of the use of requirements. Components can be produced from 0.1kg to 1500kg.
Product specifications series, RX box furnace bottom plate, RJJ carburizing furnace horse boiler, charging frame, grid plate and other components from 15kw-105kw various specifications, can be supplied in a complete set.
For heat treatment multi-purpose furnace, well furnace, continuous push rod furnace
Product specifications series, RX box furnace bottom plate, RJJ carburizing furnace horse boiler, charging frame, grid plate and other components from 15kw-105kw various specifications, can be supplied in a complete set.
It is suitable for casting and welding stirring fans of various furnace types
Jiangsu Huaye Special Steel Manufacturing Co., Ltd. , https://www.huayecasting.com